HVAC in Austin, TX

Trusted Austin HVAC Service

Austin homeowners rarely call an HVAC company when things are going well. They call when the AC dies in a heat wave, when the furnace clicks but never lights, when one bedroom stays ice cold no matter what the thermostat says. Longview HVAC built its local reputation on those calls: answering fast, arriving with stocked trucks, and fixing the actual fault instead of selling a new system. From quick capacitor swaps to full heat pump installations, our technicians handle every job with straight answers and honest numbers, and we treat your home like it belongs to a neighbor, because around here, it does.

Heating and Air Conditioning Service Across Austin

Heating and cooling around here covers a lot of ground: older gas furnaces in established neighborhoods, newer heat pumps in recent construction, ductless mini-splits in additions and converted garages, and packaged units on commercial buildings. Our team works on every one of those systems. We have years of field experience, and we've learned how the local climate, the age of local homes, and code requirements affect the way a system performs over time.

On the residential side, we take care of everything from quick fixes, like a failed capacitor, a burned contactor, a dirty flame sensor, or a seized blower motor, to tracking down refrigerant leaks, full system change-outs, and ductless additions. Every new system we install is sized with a proper load calculation rather than guesswork, so you get even temperatures and reasonable utility bills instead of a unit that short-cycles itself to an early death. Our seasonal tune-ups clean coils, verify refrigerant charge, test safety controls, and check static pressure, still the most reliable way to extend equipment life.

Local businesses receive the same attention. An overheated storefront or a freezing office drives customers and staff away, so our commercial crews focus on getting to the cause quickly and keep common parts on board for rooftop units, split systems, and ventilation equipment. Property managers, restaurant owners, and retailers can count on us to schedule work around their operating hours whenever possible.

When Your System Fails in Austin

Heating and cooling failures rarely wait for a convenient day, which is why we offer prompt, flexible scheduling for most situations. When you call, you'll speak with a real person who will get a technician dispatched to your property quickly. Arrival in the area is usually within a day for urgent calls, and a dead AC in a heat wave or a furnace out on a freezing night is exactly the kind of call we move to the front of the line.

Common emergencies we handle include air conditioners blowing warm air, outdoor units that hum but won't start, furnaces that ignite and then shut down, breakers that trip whenever the system starts, iced-over evaporator coils, clogged condensate drains backing up into the furnace cabinet, and thermostats that have simply given up. Our trucks carry the capacitors, contactors, igniters, flame sensors, universal control boards, and fittings needed to finish most repairs in a single visit. Pricing is always upfront, so you know exactly what the work will cost before we begin.

Two common situations call for quick action from you before our technician gets there. The first is an iced-over air conditioner: turn the system off at the thermostat and set the fan to "on" so warm indoor air thaws the coil, because running it frozen can flood the drain pan and damage the compressor. The second is a furnace that short-cycles or produces a burning smell. Turn it off at the service switch and call us. Those few minutes can prevent a much larger repair.

Getting More Years From Your HVAC System in Austin

Most mid-season breakdowns start with maintenance that never happened, and the habits that prevent them are simple. Change your filter every one to three months, clear vegetation at least two feet from the outdoor condenser, and rinse the condenser coil once a year in spring. Then book a professional tune-up each spring and fall, one for cooling and one for heating, so our technicians can catch small problems while they're still cheap to fix.

Equipment age matters just as much. With regular service, a central air conditioner typically lasts 12 to 15 years, a furnace 15 to 20, and a heat pump 10 to 15. Once a system passes that range and starts acting up, like rising energy bills, rooms that never reach the setpoint, or repeat service calls, it's smart to start planning a replacement. Replacing on your own schedule costs less and causes far less stress than an emergency swap during the worst heat wave of summer.

The sooner you call about a comfort problem, the smaller the repair tends to be. A weak capacitor is an easy, low-cost part to replace, yet that same capacitor, ignored for a season, can ruin the compressor and force a full system replacement. Save our number on your phone now so you can reach us fast the moment something seems off in your home. Early intervention saves time, money, and sleepless nights.

Comfort Challenges Austin Homeowners Face

Ask any homeowner around here what HVAC trouble looks like and you'll hear the same stories: the upstairs that never cools, the furnace that woke everyone up with a loud bang at 2am, the system that runs all day but never satisfies the thermostat. Behind those stories are predictable culprits: worn capacitors and contactors, low refrigerant charge, crushed or leaky ducts, and years of skipped maintenance. Our technicians see these problems weekly and carry the parts to fix most of them on the first trip.

What We Offer

We offer comprehensive heating and cooling solutions for area homes and businesses, including:

The Reason Austin Keeps Calling Us

Plenty of companies will sell you a new HVAC system. Longview HVAC earns trust around here by fixing the ones that don't need replacing and being straight about the ones that do. Our technicians diagnose the actual fault before quoting anything, explain your options in plain terms with real numbers, and let you decide without pressure. When replacement is the right call, we size the new system with a proper load calculation for your home's genuine demand, square footage, insulation, windows, and duct capacity, instead of defaulting to whatever's in the warehouse.

The workmanship holds up because we don't cut corners: correct refrigerant charge weighed in rather than guessed, sealed duct connections, proper condensate drainage, verified combustion and airflow on heating equipment, and clean electrical work that passes inspection without drama. We arrive when we said we would, cover your floors, haul away the old equipment, and test the full system in every mode before we pack up. That's why so much of our local work comes from repeat customers and referrals, and why we back every job with a satisfaction guarantee.

Your HVAC Questions Answered

More Areas We Cover

Live just outside this area? We likely serve your neighborhood too.